Pages

Friday 29 August 2014

Samsung Gt-S7500 Power Button Not Working Solution Ways



This solution shows the connection line paths of Samsung Galaxy Ace S7500 power switch and can be used where to apply or mend a jumper wire when the power switch terminal solder pads is already lifted or damaged.
Just follow and trace the line paths shown on the solution below.

Samsung Gt-S7500 power button Switch Jumper Ways

samsung s7500 power on-off jumper ways solution


Samsung Gt-S7500 Power Button Ways
Samsung S7500 On Off Key Jumper Solution

Just trace and apply a tiniest magnetic jumper wire on the spots shown of the above solution.

The highlighted components above is where the power switch is being connected, if these components were damaged it will result to power switch failure. You may need to check and then replace these components as well.
There is a risk that the power switch on Samsung Gt-S7500 may sometimes damaged and the switch terminal solder pads will be lifted and found hard enough to install it back. If these happens you may need to strongly bond the power switch to its original position and do a apply a jumper wire on it is one of the option.
You can use the solution above to determine which particular components you can put and solder a jumper wire when needed. 





No comments:

Post a Comment